New Carb Joint

The latest reproduction part from Trail & Trials UK

OEM part number 493-14453-00 or 493-14453-01

For all years & models of TY250 Twinshock from 1975 ( TY250B ) onwards & the TY250J

Will also fit the 1975 TY250A if it has a Mikuni Carb fitted

Not been available from Yamaha for a long time

Also standard equipment on all models of 250 , 320 , 340 & 360 Majesty Trials bikes. On the Godden Majesty models the joint had about 5mm cut off the front as the carb was closer to the airbox.

Manufactured from a mixture of natural rubber & Neoprene so flexible & air tight and will stay so for many years.

The original TY250 part tended to shrink and go hard over the years so made it difficult to fit onto the carb correctly and, consequently made fitting the carb to the inlet very difficult.

Easiest way to fit is -

1. Attach the joint to the airbox.

2. Attach the rear of the carb to the joint, before fitting to the inlet and screw both clamps up tight.

3. Pull the carb backwards until the front lines up with the inlet and slip inside.

4. Whilst pulling the carb forward as far as possible into the inlet tighten up the clamp.

And that's it!

Click here / hier / ici for our TY250 parts section